Operation Manual for Waterproof Spy Watch






A. ON/OFF: Press on/off button for 2 seconds to start the device. It gets into the standby mode (BLUE LED). Meanwhile the blue light indicator is on.

b. Take photo: In the standby mode, Press the Photo button for 1 second. One flashing blue light indicates that the device completes the photo taking and file saving job. Then it returns to the standby mode.
Note: Make sure there is adequate light in the surrounding and the camera is not blocked by other items. Keep the camera upright and stable. And the object should be more than 50cm from the camera.

c. Record video: In the standby mode , long press video button 2 seconds, the red light flashes 3 times and now it is recording (no light).. To stop the recording, short press photo button twice, the recording will stop and saved. Now LED in blue standby mode.  Press the ON / OFF for 3 second.. red LED will blink 3 times will OFF the device.

d. Record sound: In the standby mode, Long press photo/Sound Button for 3 second, the RED LED blink 3 times, now it is in recording. To stop the sound recording, just short press once the Photo/sound button, files will saved and watch go to standby mode again (Blue LED).

e. PC camera: Plug the watch with USB cable to computer (computer detect the flash drive). Now Press ON/OFF button, The watch will change to PC camera mode (driver installation started for the first time use). In this mode, your camera can be used as a PC camera, with your friends online video chat, take photos, and so on.
Note: According to the computer system configuration or difference, the computer may not detect a camera function by once, if the computer can not enter the camera function, but into a Udisk. Please remove the camera and connect the camera to the computer again; If you are the first time to use the PC camera function on your computer, please install the drivers on the CD or dealers provided. Please connect the data cable to the device at first, then connect the other side to the Computer.

f.Connect the computer: In standby or OFF mode, you can connect the device with the computer. The computer will pop up a removable disk logo. There is an image file directory for: * Disk \ _REC \ 100MEDIA. During video recorder and computer transfer data, the blue light flashes rapidly. For the disconnection, please click ‘SAFELY REMOVE HARDWARE’ on the right bottom corner of the task bar. Then click to stop the ‘USB mass storage device’. Unplug the USB. The disconnection completes.
Note: According to the computer or system configuration, there will be slight difference for the time of identifying removable disk. Please be patient. During this period, please do not press the button to avoid the bad impact of computer hardware. If the computer does not identify the removable disk long time, disconnect and reconnect the device. If the computer is unable to identify the hardware yet, make sure your operating system, driver and USB cable are all in normal condition. Please make sure to disconnect the device in accordance with the normal process to avoid the possible damage for computer and recorder.

g.Charge: Connect to computer USB interface or charger. During the charging, the red light flashes slowly. When the battery is fully recharged, the red light stops flashing.
Note: The recorder is with built-in high-capacity lithium polymer battery. The battery is with no memory effect. It can be used and charged at anytime. But for the initial five times of charging, please charge battery to saturation after the battery runs out. It is to activate the battery maximum capacity and maintain the standard working time.
h. Change Time: To set the time on the photo/video, just open a text file (notepad), Type time according this format: 2011-09-21 18:00:36 in the notepad and save as time.txt in watch memory (root directory / most outside). Then plug out the USB. Now time is set.