A. ON/OFF: Press on/off button for 2 seconds to start the device. It gets into the video standby mode (BLUE LED). Meanwhile the blue light indicator is on.

b. Record video: In the video standby mode , short press ON/OFF Buttom, the blue light flashes 3 times and now it is recording (no light).. To stop the recording, short press ON/OFF button twice, the recording will stop and saved. Now LED in blue standby mode.  Press the ON / OFF for 3 second.. red LED will blink 3 times will OFF the device.

c. Take photo: In the video standby mode, Press the switch mode button for once. The RED LED Ligth up, now in photo standby mode.  To take photo, short press ON/Off Button once, it will take one photo (RED LED Blink once). Press again to take again.
Note: Make sure there is adequate light in the surrounding and the camera is not blocked by other items. Keep the camera upright and stable. And the object should be more than 50cm from the camera.

e: AV Playback on TV: Connect AV cable to TV AV, press ON/Off button 2 second (now in Blue LED light up / standby mode). Press mode switch twice (LED RED and BLUE light up together), now in AV playback standby mode. Press ON/Off button once to start playback. press again to stop . To play next files, long press mode switch to play next files. Short press switch mode to jump out from AV playback mode.

f. PC camera: Plug the watch with USB cable to computer (computer detect the flash drive). Now Press ON/OFF button, The watch will change to PC camera mode (driver installation started for the first time use). In this mode, your camera can be used as a PC camera, with your friends online video chat, take photos, and so on.
Note: According to the computer system configuration or difference, the computer may not detect a camera function by once, if the computer can not enter the camera function, but into a Udisk. Please remove the camera and connect the camera to the computer again; If you are the first time to use the PC camera function on your computer, please install the drivers on the CD or dealers provided. Please connect the data cable to the device at first, then connect the other side to the Computer.

g.Connect the computer: In standby or OFF mode, you can connect the device with the computer. The computer will pop up a removable disk logo. There is an image file directory for: * Disk \ _REC \ 100MEDIA. During video recorder and computer transfer data, the blue light flashes rapidly. For the disconnection, please click ‘SAFELY REMOVE HARDWARE’ on the right bottom corner of the task bar. Then click to stop the ‘USB mass storage device’. Unplug the USB. The disconnection completes.
Note: According to the computer or system configuration, there will be slight difference for the time of identifying removable disk. Please be patient. During this period, please do not press the button to avoid the bad impact of computer hardware. If the computer does not identify the removable disk long time, disconnect and reconnect the device. If the computer is unable to identify the hardware yet, make sure your operating system, driver and USB cable are all in normal condition. Please make sure to disconnect the device in accordance with the normal process to avoid the possible damage for computer and recorder.

h.Charge: Connect to computer USB interface or charger. During the charging, the red light flashes slowly. When the battery is fully recharged, there is no light.

Note: The recorder is with built-in high-capacity lithium polymer battery. The battery is with no memory effect. It can be used and charged at anytime. But for the initial five times of charging, please charge battery to saturation after the battery runs out. It is to activate the battery maximum capacity and maintain the standard working time.