IP Camera: How to Set the IP Camera NSD Model? Suitable for ID start with PPCN-XXX-XXXX

IP Camera Setting:


There are many way to set and view at different portal.
You can view from your smartphone / tablet  (either Android or IPhone), or On the computer for single monitoring or centralized monitoring for concurrent many camera at once place.


Setting and View Via Smartphone:
For smartphone apps ( android and Apple IOS ), you can got it on the provided CD, or Get from Apps Store / Play store for P2PWIFICAM software.
Just install the apps and start follow below pdf manual below (provided in the CD as well).

Android: Wifi Instruction for Android Phones.pdf
Apple IOS: Wifi Instruction for Apple iphone.pdf



How to Setting the IP Camera NSD/WSD Model & Monitor Via PC:

1. Please connect your IP Camera Via LAN Cable to your Router LAN Port and then Power ON.

2. Open SearchTools Software (Provided in CD), and click search. (if you can't get search, please reset the IP camera at the bottom of IP Camera and try again).
    To reset, in power ON condition, press the reset switch for few second and it will restart.
    
     

3. Device found and the IP shown. Click on the IP will bring you to the IP camera interface.
     
4. Click the video stream (for firefox) - becuase i am using firefox. and you will bring to IP camera Video stream page.
     
5. Click the setting to go setting page and you can change the language as in picture.

6. Next you can do setting the time / alarm / motion / SD card recording (for WSD model) and also connect the IP Camera via wifi to your router instead of LAN.
    We have capture some picture for your reference.

     
     
     
     
     
     
     
     



Monitoring Via Centralized monitoring software

1. Please connect your IP Camera Via LAN Cable to your router LAN Port and then Power ON.

2. Install the centralized Monitoring software (device client) and start the software.

3. Follow the instruction as per in picture below for the setting. Done.

     
     
     


Pls note:
Some computer due to permission setting, you unable to see the Device Client software coming out after you clicked it. It is permission matter.
Just right click and select properties on Device Client icon, and go security tab, at the gropu of user (select the user that are using this computer) and tick allow for full control and others, then it should be ok.


Thanks.