Operating
:
A.
ON/OFF:
Press on/off button for 2 seconds to start the device. It gets into the
video standby mode (BLUE LED). Meanwhile the blue light indicator is on.
b.
Record video:
In the video standby mode , short press ON/OFF Buttom, the blue light
flashes 3 times and now it is recording (no light).. To stop the
recording, short press ON/OFF button twice, the recording will stop and
saved. Now LED in blue standby mode. Press the ON / OFF for 3 second..
red LED will blink 3 times will OFF the device.
c.
Take photo:
In the video standby mode, Press the switch mode button for once. The
RED LED Ligth up, now in photo standby mode. To take photo, short press
Photo Button once, it will take one photo (RED LED Blink once). Press
again to take again.
Note: Make sure there is adequate light in the surrounding and the
camera is not blocked by other items. Keep the camera upright and
stable. And the object should be more than 50cm from the camera.
d.
PC camera:
Plug the watch with USB cable to computer (computer detect the flash
drive). Now Press ON/OFF button, The watch will change to PC camera
mode (driver installation started for the first time use). In this
mode, your camera can be used as a PC camera, with your friends online
video chat, take photos, and so on.
Note: According to the computer system configuration or difference, the
computer may not detect a camera function by once, if the computer can
not enter the camera function, but into a Udisk. Please remove the
camera and connect the camera to the computer again; If you are the
first time to use the PC camera function on your computer, please
install the drivers on the CD or dealers provided. Please connect the
data cable to the device at first, then connect the other side to the
Computer.
e.Connect the
computer: In standby or
OFF mode, you
can connect the device with the computer. The computer will pop up a
removable disk logo. There is an image file directory for: * Disk
_REC 100MEDIA. During video recorder and computer transfer data, the
blue light flashes rapidly. For the disconnection, please click
‘SAFELY
REMOVE HARDWARE’ on the right bottom corner of the task bar.
Then click
to stop the ‘USB mass storage device’. Unplug the
USB. The
disconnection completes.
Note: According to the computer or system configuration, there will be
slight difference for the time of identifying removable disk. Please be
patient. During this period, please do not press the button to avoid
the bad impact of computer hardware. If the computer does not identify
the removable disk long time, disconnect and reconnect the device. If
the computer is unable to identify the hardware yet, make sure your
operating system, driver and USB cable are all in normal condition.
Please make sure to disconnect the device in accordance with the normal
process to avoid the possible damage for computer and recorder.
f.Charge:
Connect to computer USB interface or
charger. During the charging, the red light flashes slowly. When the
battery is fully recharged, there is no light.
Note:
The recorder is with built-in high-capacity lithium polymer battery.
The battery is with no memory effect. It can be used and charged at
anytime. But for the initial five times of charging, please charge
battery to saturation after the battery runs out. It is to activate the
battery maximum capacity and maintain the standard working time.
g.
Change Time: To set the time
on the photo/video, just open a text file (notepad), Type time
according this format: 2011-09-21 18:00:36 in the notepad and save as
time.txt in watch memory (root directory / most outside). Then plug out
the USB. Now time is set.
FAQ - Frequently
Asked Questions
- How
can I reset the watch?
Press the ON/OFF key and Photo/Sound key at the same time.